Seeing an FE error code on your modern Whirlpool dryer can be a bit puzzling, but don’t fret! This specific code indicates a ‘Pump Circuit Fault,’ essentially meaning there’s an issue detected with the dryer’s drain pump or its associated electrical circuit. It’s often related to a drainage problem, especially if your dryer has a steam function that relies on water.
Possible Issues
- A faulty drain pump (common in steam-equipped dryers).
- Blockages or clogs within the drain hose or the pump itself.
- Potential wiring issues affecting the connection to the drain pump.
- A malfunctioning electronic control board that manages the pump’s operation.
[JUSTANSWER_WIDGET]
Troubleshooting Steps
-
Perform a Power Cycle:
- Locate your dryer’s power cord and unplug it from the wall outlet.
- Wait a full two minutes. This allows the internal system to fully reset any temporary glitches.
- Plug the dryer back into the outlet.
- Attempt to start a cycle to see if the error has cleared.
-
Inspect Drain Pump and Hoses (if applicable for steam models):
- If the error persists and your dryer utilizes a drain pump (typically found in models with steam features), carefully inspect the drain hose for any kinks, twists, or obvious clogs.
- Check the drain pump filter, if it is an accessible component on your model, for any accumulated debris.
-
Advanced Diagnosis (If Error Persists):
- Should the FE code remain after attempting a power cycle and conducting a basic visual inspection, the root cause likely lies deeper within the appliance. This scenario often points towards a failing drain pump unit itself or a fault within the electronic control board’s circuit responsible for managing the pump.
- At this stage, professional assistance is usually recommended. Such issues typically involve internal component checks and electrical testing that are best performed by a qualified technician.
Need to replace the Drain Pump, Electronic Control? Check prices here: [REPAIR_LINK]